But here's a quickie break down of what's gone on.
Here's the stock turn signal switch. If you're wondering, that shit that looks like some kind of rtv-like rubber sealant is.
So after I got all that shit off I removed the old brittle wires and soldered on some nice new ones, being careful to note the factory wiring diagram so the switch functions as it is supposed to.
Reassembly is reverse of removal.
So then I tackled the last issue with the rear end wiring, the license plate light.
It looked a bit rough.
This is a simple license plate light by trucklite that most parts stores carry.
In need of a little modification though.
After a little massaging...
All we needed was a light trimming and done.
Heading to Colby this weekend with the old lady. More after that.
Later
No comments:
Post a Comment